Product Information:
10 kg of SD 7160 hardener, used together with casting resin SR GreenCast 160 for making decorative objects, prototypes, jewelry, and river tables.
- Casting thickness up to 10 cm at 20°C
- Clear, colorless
- Cures at room temperature
- Mixing ratio 2:1
- Good UV resistance
- Excellent impact and heat resistance
- Resin component is bio-based (37%)
Working Instructions:
Mixing ratio by weight: 100/42
Mixing ratio by volume: 100/50
Pot life 20ºC: 1 h
Pot life 30ºC: 40 min
Curing time at 20°C: 48 h
Viscosity at 20°C: 360 mPas
Use in well-ventilated areas. Always wear appropriate protective equipment.
Measure resin and hardener precisely, and mix slowly to avoid air bubbles. In some applications, it can be beneficial to preheat the mixture and/or degass it under vacuum. Maximum casting thickness is approximately 100 mm.
Safety Instructions:
Use protective gloves (complying with EN374), safety goggles (EN166), protective clothing, and a respirator with gas and vapor filters (combined filters meeting EN14387).
Resin Component Hazards:
Causes skin irritation. May cause an allergic skin reaction. Causes serious eye irritation. Toxic to aquatic life with long-lasting effects. If medical advice is needed, have product packaging or label at hand. Keep out of reach of children. Contaminated work clothing should not be taken off the premises. Wear protective gloves/clothing/eye and face protection/hearing protection. If eye irritation persists, seek medical attention. Remove contaminated clothing and wash before reuse.